废水中甲基橙的电化学降解

以FTO导电玻璃作为阳极、石墨电极作为阴极电解模拟甲基橙废水,优化了工艺条件,并对甲基橙的降解机理进行了初步探究。实验结果表明,在NaCl投加量5 g/L、电压8 V、废水pH 6、初始甲基橙质量浓度6.0 mg/L的优化条件下电解30 min,废水的脱色率达91.3%,COD降低了62%。机理研究结果表明,电解产生的羟基自由基与甲基橙发生氧化还原反应,破坏了甲基橙的显色基团,使其内部某些化学键发生断裂,从而达到脱色的目的。     

三维电极电Fenton氧化法处理染料废水

采用三维电极电Fenton氧化法处理实际染料废水,探究了染料废水处理效果的影响因素。实验结果表明：以钌铱镀层钛电极为阳极、不锈钢板为阴极、粉末活性炭为颗粒电极,在粉末活性炭投加量为2.0 g/L、电流密度为0.5 mA/mm²、极板间距为3 cm、pH为2.0、硫酸亚铁投加量为0.50 g/L的最优工艺条件下,反应2 h后COD、TOC、氨氮、色度的去除率达到最大,分别为62.80%、41.15%、42.48%和95.00%;粉末活性炭作为颗粒电极可使染料废水COD去除率提高18个百分点;重复使用10次的处理效果与第2次基本持平。     

氨气敏电极法和纳氏试剂分光光度法对地表水中氨氮的比对测试

采用不同质量浓度的氨氮标准样品和实际样品,用氨气敏电极法和纳氏试剂分光光度法进行同步测试。结果表明,2种分析方法在水样氨氮质量浓度在0. 159～2. 81 mg/L范围内具有良好的可比性、精密性和准确性。氨气敏电极法的检出限为0. 03 mg/L,平行6次测定样品的相对标准偏差为0. 4%～4. 2%,加标回收率为85. 0%～110%;纳氏试剂分光光度法的检出限为0. 025 mg/L,平行6次测定样品的相对标准偏差为0. 5%～6. 4%,加标回收率为93. 0%～99. 8%。同时氨气敏电极法在样品预处理、试剂配制和分析时间上要优于纳氏试剂分光光度法。氨气敏电极法能够满足地表水自动监测在线比对实际工作的需求,该方法具有良好的适用性。     

电絮凝去除废水中多种重金属影响因素研究

目的以铁作为电极,研究电絮凝法处理含多种重金属废水的影响因素及效果。方法通过控制pH、停留时间、电流密度、电导率、废水初始浓度等因素至不同水平,考察处理效果、能耗及极板消耗的变化。结果随着停留时间、pH值及电流密度的升高,处理效果越好,但升高至一定程度后,处理效果提升并不明显;电导率对处理效果影响并不显著,但过低的电导率会增加能耗;废水初始浓度越高,要达到处理目标所需的能耗及极板消耗均越高。结论当pH为8.5~9.0、进水电导率为1500~2000μs/cm、停留时间为3~4 min、废水初始质量浓度20 mg/L、电流密度为13.2~19.8 A/m2时,处理效果最理想,对总铜、总镍、总铅、总锌、总镉及总铬的去除率达到99%以上,且能耗与极板消耗均为最低,电絮凝法更适合于重金属废水的深度处理。     

ICP-MS法测定不同类型水体可滤态与总量结果比对分析

本文运用电感耦合等离子体质谱(ICP-MS)法对不用类型水体(地下水、地表水、水库水和污水)中的10种重金属元素进行了测定和比对分析。结果显示地下水除钴元素可滤态与总量测定结果相当之外总量均大于可滤态、地表水总量均大于可滤态、水库水除锰元素和镍元素可滤态与总量测定值有较差别外其它8种元素总量与可滤态测定值均无明显差异、污水除钛元素外其余9种元素总量与可滤态测定值均无明显差异。其中,地表水与污水钛元素可滤态均未检出,总量测定值为检出限的1倍至3倍,结果可信。此结果证明对于本次用于检测的样品中的钛元素,全部来源于悬浮于水中的直径大于0.45μm的微粒上,其它元素无此特性。     

Landscape trajectory of natural boreal forest loss as an impediment to green infrastructure

Loss of natural forests by forest clearcutting has been identified as a critical conservation challenge worldwide. This study addressed forest fragmentation and loss in the context of the establishment of a functional green infrastructure as a spatiotemporally connected landscape-scale network of habitats enhancing biodiversity, favorable conservation status, and ecosystem services. Through retrospective analysis of satellite images, we assessed a 50- to 60-year spatiotemporal clearcutting impact trajectory on natural and near-natural boreal forests across a sizable and representative region from the Gulf of Bothnia to the Scandinavian Mountain Range in northern Fennoscandia. This period broadly covers the whole forest clearcutting period; thus, our approach and results can be applied to comprehensive impact assessment of industrial forest management. The entire study region covers close to 46,000 km² of forest-dominated landscape in a late phase of transition from a natural or near-natural to a land-use modified state. We found a substantial loss of intact forest, in particular of large, contiguous areas, a spatial polarization of remaining forest on regional scale where the inland has been more severely affected than the mountain and coastal zones, and a pronounced impact on interior forest core areas. Salient results were a decrease in area of the largest intact forest patch from 225,853 to 68,714 ha in the mountain zone and from 257,715 to 38,668 ha in the foothills zone, a decrease from 75% to 38% intact forest in the inland zones, a decrease in largest patch core area (assessed by considering 100-m patch edge disturbance) from 6114 to 351 ha in the coastal zone, and a geographic imbalance in protected forest with an evident predominance in the mountain zone. These results demonstrate profound disturbance of configuration of the natural forest landscape and disrupted connectivity, which challenges the establishment of functional green infrastructure. Our approach supports the identification of forests for expanded protection and conservation-oriented forest landscape restoration.     

RuO_2-IrO_2/Ti阳极电催化降解偶氮染料甲基橙模拟废水

以自制Ti基Ru O2-Ir O2镀层形稳电极为阳极,采用电催化氧化处理偶氮染料甲基橙模拟废水。以硫酸钠为支持电解质,在自然p H条件下分别考察了电解时间、电极间距、电流密度和电解质浓度等因素对甲基橙去除率的影响,并分析其原因。实验结果表明,在自然p H、电极间距为1.0 cm、电流密度为30.0 m A/cm2、电解质硫酸钠浓度为20.0 g/L、电解1.0h,甲基橙去除率高达90.0%以上。因此,电催化氧化法作为一种高效、简便的染料废水处理技术,具有一定的应用潜力。     

Microbial fuel cells: Advances in electrode modifications for improvement of system performance

There is an increasing trend to conduct the researches related to Microbial Fuel Cells (MFCs) in the recent years. Limited power output has been the major obstacle for the practical application and upscaling of MFCs. Attempts have been made on electrode modifications such as anode treatments, cathode modifications with catalysts and bio cathodes developments to produce varying degrees of improved output current depending upon the types of modifications. Power density and Coulombic efficiency have been considered as the important parameters to analyze the system performances. This paper overviews on the advances made in MFCs’ researches focusing on different types of electrodes modifications along with the involved methodology. Furthermore, the system performances of different modified MFCs are compared in terms of the power density and the Coulombic efficiency.     

新型二氧化铅电极处理染料废水

利用高压塑片法制备掺杂镧和活性炭以及聚四氟乙烯(PTFE)的新型二氧化铅电极,采用X衍射(XRD),循环伏安曲线(CV),扫描电镜(SEM)等手段对电极性能进行表征,研究了其电催化处理有机染料废水(亚甲基蓝)的降解效果,并对反应机理进行了相关研究。研究表明,该电极具有良好的抗腐蚀能力,对亚甲基蓝具有较好的降解效果。通过与普通二氧化铅电极比较,该电极在染料脱色和去除COD方面都有较明显优势,显示出较好的工业应用前景。     

钛基金属氧化物电极的制备及性能

采用聚合物前驱体法制备了Ti/SnO₂-Sb₂O₃电极，再通过恒电流电沉积法制备了 Ti/SnO₂-Sb₂O₃/PbO₂和Ti/SnO₂-Sb₂O₃/MnO₂电极。采用SEM技术对3种金属氧化物电极表面的形貌进行了表征，并分别以3种电极为阳极进行了苯酚的电催化氧化实验。实验结果表明：电解时间为2.5 h时，Ti/SnO₂-Sb₂O₃电极、Ti/SnO₂-Sb₂O₃/PbO₂电极和Ti/SnO₂-Sb₂O₃/MnO₂电极对苯酚的降解率分别为85.9%，83.2%，44.6%；苯酚在3种电极上的电催化氧化反应均遵循一级反应动力学方程；苯酚在Ti/SnO₂-Sb₂O₃ 电极和Ti/SnO₂-Sb₂O₃/PbO₂电极上的反应速率较快，并具有较高的析氧电位；Ti/SnO₂-Sb₂O₃/PbO₂电极具有更好的耐腐蚀性和更长的使用寿命。